wiki:crkit/Hardware/RFBoards/bWDR
close Warning: Can't synchronize with repository "(default)" (/common/SVN/crkit does not appear to be a Subversion repository.). Look in the Trac log for more information.

Wide-tuning RF Module (WDR)

Table of Contents

    WDR Block Diagram

    • RF tuning range from 300 to 7500 MHz using heterodyne downconversion and sharp IF filtering for excellent adjacent channel rejection.
    • Full duplex operation over entire tuning range allows any combination of uplink and downlink frequency sets.
    • Selectable receiver I/Q analog bandwidth of 7, 10, 15 or 20 MHz digital sampling rate of 64 MSps on I/Q with 12 bit ADC.
    • Receiver noise figure (NF) of 6 dB, gain control of 80 dB.
    • Selectable transmitter I/Q analog bandwidth of 12, 18 or 24 MHz, digital update rate of 128 MSps with 14 bit DAC.
    • Transmitter output of +20 dBm minimum across entire band, 32dB gain control, carrier feedthru suppression and I/Q sideband balance control.
    • Upto four radio channels can be configured asynchronously or locked together for phased or smart antenna applications.
    • Accepts external GPS frequency locking for standards based timing.
    • Frequency hop of less than 50usec.
    • Switched antenna diversity for both TX and RX channels.

    SPI block is used for control of all elements.

    Last modified 12 years ago Last modified on May 1, 2012, 4:51:24 PM

    Attachments (12)

    Note: See TracWiki for help on using the wiki.