Build Framework

Once app_sub.ngc has been copied to current ISE project folder, we are now ready to build the framework and generate a bit file for FPGA download.

Perform following operations :

1. Start Xilinx ISE
   
2. Open CRKit project located at d:\hw\cr_build\cr_r3_sim\cr_r3.ise . The opened project should look like as shown in Figure 1.

Figure 1 - ISE cr_r3 project

3. You have the option to re-synthesize the framework. Note the application module e.g. app_sub.ngc is not synthesized at this stage, this has been done within MATLAB/Simulink. To synthesize the framework, right-click on Synthesize - XST in processes window, and select run or re-run. This step can be skipped if you already have synthesize the framework at an earlier stage, hence save some build time.
   
   
4. Proceed with the place/route stage. Right-click on Implement Design in processes window, and select run or re-run. Once this step is completed succesfully, you should see All Signals Completely Routed and All Constraints Met under the project status as shown in Figure 2.
   
   

Figure 2 - Project Status

5. Generate bit file. Right-click on 'Generate Programming File' in processes window, and select run or re-run. Once this step is done, the bit file is available at d:\hw\cr_build\cr_r3_sim\cr_top.bit .